Skip to content

Amdro Mole & Gopher Bait

by Amdro
$17.09
Size
  • Product Overview
  • Benefits
  • Target Pests
  • Product Overview

    Amdro Mole and Gopher Bait is a ready-to-use pelleted bait formulation that helps eliminate lawn-damaging animals such as moles and gophers in residential environments such as lawns and gardens. It's convenient 1 lb. shaker canister makes for easy, effective, safe application.

    Amdro Mole & Gopher Bait is not approved for use on moles in CA, IN or NC.

  • Benefits & Use

    Amdro Mole & Gopher Bait provides an easy-to-apply, effective remedy for individuals wanting an effective solution to their mole or gopher problem. 
  • Target Pests

    Amdro Mole & Gopher Bait is specifically formulated for effectiveness against moles and gophers, and should not be used to combat other pests.
  • Product Video
  • Label / SDS
  • Tech Specs
  • Product Video

  • Label / SDS

    Product Label

    Safety Data Sheet 

     

  • Tech Specs

    Active Ingredient: Zinc Phosphide 2%

    Manufacturer: Amdro

    Formulation: Granular Bait

    Approved Sites: Outdoors per label instructions.

    Application Information:

    Application Directions

    For Pocket Gophers: Apply bait to control pocket gophers using one of the two methods outlined below:

    1. Plug Removal Baiting: Burrowing pocket gophers throw out low, fan shaped mounds on either side of their underground tunnel. These lateral tunnels coming to the surface are on the flat side of the fan and are plugged with soil. Using a long-handled spoon, carefully remove the plug. Insert one teaspoon of bait as far down as possible. Reclose opening, being careful not to cover bait with soil.

    2. Main Runway Baiting: To locate main runways, probe about 6 to 8 inches away from mounds by use of an iron bar, a strong stick, or other suitable implement. Resistance on probe will drop suddenly and probe will fall about two inches when main runway is entered. Carefully enlarge the opening to accommodate insertion of the bait. Insert one teaspoon of bait into each active tunnel. Carefully close the hole with a stone, sod, or soil. Take care not to cover bait with soil.

    For Moles: The presence of moles may be indicated by a network of surface ridges in the turf, by a series of conical mounds of earth pushed up from deep burrows.

    Surface Ridges: Prior to treatment, determine which burrows are active according to one of the following two methods. Either press down a small section of the tunnel or remove a one-inch section of the tunnel's roof. Mark these sections and recheck in 24 hours. The burrow is considered active if the flattened runway has been raised up or if the roof has been repaired. Only treat active burrows.

    Carefully punch a hole in the top of active tunnels, drop a teaspoonful amount of bait and carefully close the hole with sod or stone. Do not collapse the runway again or allow loose soil to cover the bait. After a few days check to see if the burrows are still active according to one of the two methods described above. If so, repeat treatment.

    Conical Mounds: Remove center plug from the conical mounds with a long-handled spoon and drop a teaspoonful amount of bait in the underground tunnel. Close opening with rock or sod. Do not allow loose dirt to cover bait.

    Follow-up: Wearing waterproof gloves, collect and dispose of dead, exposed animals. Dispose of leftover bait in accordance with disposal instructions. Use detergent and hot water to wash spoons used for application into burrows. Do not use spoon for mixing, holding or transferring food or feed. If reinfestation does occur, repeat treatment.

    *Not for use on moles in CA, IN or NC

    Not For Sale To: CA, IN, NC

    EPA Registration: 12455-30-73342